Use typographic quotation marks -- correct more places
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@25917 a1c6a512-1295-4272-9138-f99709370657
diff --git a/manual/advanced_topics/archos-flashing.tex b/manual/advanced_topics/archos-flashing.tex
index 4f6c622..c6209be 100644
--- a/manual/advanced_topics/archos-flashing.tex
+++ b/manual/advanced_topics/archos-flashing.tex
@@ -42,7 +42,7 @@
garbled flash content: the \emph{UART} boot mod, which in turn requires the
\emph{serial} mod. With that it's possible to reflash independently from the
outside, even if the flash ROM is completely erased.
-\nopt{ondio}{This won't work if you have one of the rare "ROMless" boxes. These
+\nopt{ondio}{This won't work if you have one of the rare ``ROMless'' boxes. These
have no boot ROM and boot directly from flash.
}
If the first $\approx$2KB of the flash ROM are flashed ok, \emph{Minimon} can
@@ -78,7 +78,7 @@
You only need to perform this procedure the first time you flash your
\playertype. You may also want to perform it in case the update procedure for
the second image recommends it. In the latter case do not perform the steps
-listed under "Preparation".
+listed under ``Preparation''.
\subsubsection{Preparation}
@@ -87,10 +87,10 @@
\setting{System $\rightarrow$ Debug (Keep Out!) $\rightarrow$ View HW
Info}.
\opt{lcd_charcell}{Cycle through the displayed values with \ButtonRight /
- \ButtonLeft\ until "Flash:" is displayed. If it shows question marks,
+ \ButtonLeft\ until ``Flash:'' is displayed. If it shows question marks,
}
- \opt{lcd_bitmap}{Check the values in the line starting with "Flash:". If it
- shows question marks after "M=" and "D=",
+ \opt{lcd_bitmap}{Check the values in the line starting with ``Flash:''. If it
+ shows question marks after ``M='' and ``D='',
}
you're out of luck, your \dap\ is not flashable without modifying the
hardware. You can stop here. Sorry.